JO 7210.3 Facility Operation and AdministrationJO 7210.3EE · Change 3 · Effective 7/9/2026
Chapter 3 · Section 7
Video Maps
5 Paragraphs3-7-1–3-7-5
3-7-1 TOLERANCE FOR RADAR FIX ACCURACY
Careful attention must be given during commissioning flight checks of a radar to the accuracy of digital maps, video map plates, or overlays to ensure that the plate or overlay markings meet specified requirements relative to permanent targets. In actual practice an aircraft's displayed position can be slightly in error with respect to its geographic position and still meet the requirements of FAA Order 8200.1, United States Standard Flight Inspection Manual.
3-7-2 RADAR MAPPING STANDARDS
The minimum radar mapping capability required for commissioning radar services is one of the following:
Dual video mapper.
Adequate map overlay.
Single video mapper plus a map overlay.
AN/GPA-70 at USAF installations.
AN/GPA-91 at Navy installations.
Computer-generated displays.
NOTE
Grease pencil markings, plastic tape, compass rose grid lines, range marks, or other innovations must not be used in lieu of an adequate digital map, map overlay, or video map.
3-7-3 DISPLAY MAP DATA
To reduce scope clutter and increase operational efficiency, limit data on display maps to the following (except for subparagraph o, facility air traffic managers may delete items not required):
Airports/heliports.
NOTE
Mission Support Services, Aeronautical Information Services, AJV-A2 will verify the accuracy of video maps they produce to ensure the video maps depict only operational airports as defined by the Office of Airport Safety and Standards, AAS-1. Facilities will be notified by AJV-A2 that new radar video maps (RVMs) will be sent when a depicted airport is no longer operational.
Runway centerline extension and/or final approach course.
REFERENCE
FAA Order JO 7110.65, Para 5-9-1, Vectors to Final Approach Course.
Hospital emergency landing areas.
NAVAIDs and fixes.
Reporting points.
Airway/route centerlines.
Boundaries (control, special use areas, terminal buffer areas, outer fix holding pattern airspace areas, no transgression zones, etc.).
Handoff points.
Special use tracks (scramble, recovery, Instrument Departures, etc.).
Obstructions.
Prominent geographic features (islands, mountains, etc.).
Map alignment indicators.
Range accuracy marks.
Minimum vectoring altitudes in hundreds of feet; e.g., 23-2,300 ft., 100-10,000 ft.
Airports immediately outside your area of jurisdiction that are:
Within airspace used to receive radar handoffs; and
Depicted by the facility having jurisdiction over that airspace.
Virtual intersection markings for non-intersecting converging runways if the flight paths intersect within 1NM beyond the departure end of both runways.
NOTE
The intent of subparagraph o is to assist controllers in making emergency airport recommendations when inflight emergencies occur near facility boundaries. There is no intent to establish criteria for airport depiction. However, insofar as facilities having jurisdiction depict airports, then those same airports must be depicted on the adjacent facility's video map.
REFERENCE
FAA Order JO 7110.65, Para 10-2-15, Emergency Airport Recommendation.
3-7-4 INTENSITY
Set the intensity of the video map and the range marks on the CTRD equipment at the minimum intensity that will provide the controller with the necessary information. Supervisory personnel must ensure that a usable intensity is maintained.
3-7-5 COMMON REFERENCE POINTS
Facility air traffic managers must ensure the adequacy of common reference points on radar maps where such points are used in providing air traffic control services; e.g., handoff points, etc., between adjacent facilities or between sectors within the facilities using different radar systems. Whenever possible, simultaneous flight checks should be conducted of these radar systems. FAA Order 8200.1, United States Standard Flight Inspection Manual, must be used in determining the appropriate tolerances.