Skip to Main Content
FlightPushFLIGHTPUSH
Chapter 3

Learn

Dashboard My Courses Mastery Map Practice Flight Bag

Resources

CFR & AIM FAA Orders Handbooks & Guides Certification Standards Pilot/Controller Glossary Advisory Circulars Legal Interpretations
Safety Center
Articles Trust Center
Help Center FAQ Status
  1. Reference Library
  2. FAA Orders
  3. JO 7110.65
  4. Chapter 3
  5. Section 11
Loading
flightpush.co home
JO 7110.65 Air Traffic Control
  1. Chapter 1. General

    Section 1. Introduction
  2. Section 2. Terms of Reference
  3. Chapter 2. General Control

    Section 1. General
  4. Section 2. Flight Plans and Control Information
  5. Section 3. Flight Progress Strips
  6. Section 4. Radio and Interphone Communications
  7. Section 5. Route and NAVAID Description
  8. Section 6. Weather Information
  9. Section 7. Altimeter Settings
  10. Section 8. Runway Visibility Reporting- Terminal
  11. Section 9. Automatic Terminal Information Service Procedures
  12. Section 10. Team Position Responsibilities
  13. Chapter 3. Airport Traffic Control - Terminal

    Section 1. General
  14. Section 2. Visual Signals
  15. Section 3. Airport Conditions
  16. Section 4. Airport Lighting
  17. Section 5. Runway Selection
  18. Section 6. Airport Surface Detection Procedures
  19. Section 7. Taxi and Ground Movement Procedures
  20. Section 8. Spacing and Sequencing
  21. Section 9. Departure Procedures and Separation
  22. Section 10. Arrival Procedures and Separation
  23. Section 11. Helicopter Operations
    1. 3-11-1 TAXI AND GROUND MOVEMENT OPERATION
    2. 3-11-2 HELICOPTER/POWERED‐LIFT TAKEOFF CLEARANCE
    3. 3-11-3 HELICOPTER/POWERED‐LIFT DEPARTURE SEPARATION
    4. 3-11-4 HELICOPTER/POWERED‐LIFT ARRIVAL SEPARATION
    5. 3-11-5 SIMULTANEOUS LANDINGS OR TAKEOFFS
    6. 3-11-6 HELICOPTER/POWERED‐LIFT LANDING CLEARANCE
  24. Section 12. Sea Lane Operations
  25. Chapter 4. IFR

    Section 1. NAVAID Use Limitations
  26. Section 2. Clearances
  27. Section 3. Departure Procedures
  28. Section 4. Route Assignment
  29. Section 5. Altitude Assignment and Verification
  30. Section 6. Holding Aircraft
  31. Section 7. Arrival Procedures
  32. Section 8. Approach Clearance Procedures
  33. Chapter 5. Radar

    Section 1. General
  34. Section 2. Beacon/ADS-B Systems
  35. Section 3. Radar Identification
  36. Section 4. Transfer of Radar Identification
  37. Section 5. Radar Separation
  38. Section 6. Vectoring
  39. Section 7. Speed Adjustment
  40. Section 8. Radar Departures
  41. Section 9. Radar Arrivals
  42. Section 10. Radar Approaches- Terminal
  43. Section 11. Surveillance Approaches- Terminal
  44. Section 12. PAR Approaches- Terminal
  45. Section 13. Automation- En Route
  46. Section 14. Standard Terminal Automation Replacement System (STARS)-Terminal
  47. Chapter 6. Nonradar

    Section 1. General
  48. Section 2. Initial Separation of Successive Departing Aircraft
  49. Section 3. Initial Separation of Departing and Arriving Aircraft
  50. Section 4. Longitudinal Separation
  51. Section 5. Lateral Separation
  52. Section 6. Vertical Separation
  53. Section 7. Timed Approaches
  54. Chapter 7. Visual

    Section 1. General
  55. Section 2. Visual Separation
  56. Section 3. VFR‐On‐Top
  57. Section 4. Approaches
  58. Section 5. Special VFR (SVFR)
  59. Section 6. Basic Radar Service to VFR Aircraft- Terminal
  60. Section 7. Terminal Radar Service Area (TRSA)-Terminal
  61. Section 8. Class C Service- Terminal
  62. Section 9. Class B Service Area- Terminal
  63. Chapter 8. Offshore/Oceanic Procedures

    Section 1. General
  64. Section 2. Coordination
  65. Section 3. Longitudinal Separation
  66. Section 4. Lateral Separation
  67. Section 5. Offshore/Oceanic Transition Procedures
  68. Section 6. Separation from Airspace Reservations
  69. Section 7. North Atlantic ICAO Region
  70. Section 8. Caribbean ICAO Region
  71. Section 9. Pacific ICAO Region
  72. Section 10. North American ICAO Region
  73. Chapter 9. Special Flights

    Section 1. General
  74. Section 2. Special Operations
  75. Section 3. Special Use, ATC-Assigned Airspace, and Stationary ALTRVs
  76. Section 4. Fuel Dumping
  77. Section 5. Jettisoning of External Stores
  78. Section 6. Unmanned Free Balloons
  79. Section 7. Parachute Operations
  80. Section 8. Unidentified Anomalous Phenomena (UAP) Reports
  81. Chapter 10. Emergencies

    Section 1. General
  82. Section 2. Emergency Assistance
  83. Section 3. Overdue Aircraft
  84. Section 4. Control Actions
  85. Section 5. Miscellaneous Operations
  86. Section 6. Oceanic Emergency Procedures
  87. Section 7. Ground Missile Emergencies
  88. Chapter 11. Traffic Management Procedures

    Section 1. General
  89. Chapter 12. Canadian Airspace Procedures

    Section 1. General Control
  90. Chapter 13. Decision Support Tools

    Section 1. ERAM - En Route
  91. Section 2. ATOP - Oceanic
  92. Chapter 14. Data Link Communications

    Section 1. Terminal Procedures for Issuing Automated Clearances
  93. Section 2. En Route Controller Pilot Data Link Communications (CPDLC) - Domestic
  94. Section 3. Advanced Technologies and Oceanic Procedures (ATOP) - Oceanic Controller Pilot Data Link Communications (CPDLC)
  95. Appendices

    Appendix A. Standard Operating Practice (SOP) for the Transfer of Position Responsibility
  96. Appendix B. Standard Operating Practice (SOP) for Aircraft Deviating for Weather Near Active Special Activity Airspace (SAA)

JO 7110.65 Air Traffic Control|JO 7110.65BB · Change 3 · Effective 7/9/2026

Chapter 3 · Section 11

Helicopter Operations

6 Paragraphs|3-11-1–3-11-6

Read Citation (on FlightPush)

3-11-1 TAXI AND GROUND MOVEMENT OPERATION

a.

When necessary for a wheeled helicopter or powered‐lift aircraft to taxi on the surface, use the phraseology in paragraph 3-7-2, Taxi and Ground Movement Operations.

NOTE

Ground taxiing uses less fuel than hover‐taxiing and minimizes air turbulence. However, under certain conditions, such as rough, soft, or uneven terrain, it may become necessary to hover/air‐taxi for safety considerations. Helicopters with articulating rotors (usually designs with three or more main rotor blades) are subject to “ground resonance” and may, on rare occasions, suddenly lift off the ground to avoid severe damage or destruction.

b.

When requested or necessary for a helicopter or powered‐lift aircraft to proceed at a slow speed above the surface, normally below 20 knots and in ground effect, use the following phraseology, supplemented as appropriate with the phraseology in paragraph 3-7-2, Taxi and Ground Movement Operations.

PHRASEOLOGY

HOVER‐TAXI (supplemented, as appropriate, from paragraph 3-7-2, Taxi and Ground Movement Operations.) CAUTION (dust, blowing snow, loose debris, taxiing light aircraft, personnel, etc.).

NOTE

Hover‐taxiing consumes fuel at a high burn rate, and helicopter downwash turbulence (produced in ground effect) increases significantly with larger and heavier helicopters.

REFERENCE

P/CG Term- Hover Taxi. AIM, Para 4-3-17, VFR Helicopter Operations at Controlled Airports.

c.

When requested or necessary for a helicopter or powered‐lift aircraft to proceed expeditiously from one point to another, normally below 100 feet AGL and at airspeeds above 20 knots, use the following phraseology, supplemented as appropriate with the phraseology in paragraph 3-7-2, Taxi and Ground Movement Operations.

PHRASEOLOGY

AIR‐TAXI: VIA (direct, as requested, or specified route) TO (location, heliport, helipad, vertiport, vertipad operating/movement area, active/inactive runway). AVOID (aircraft/vehicles/personnel). If required, REMAIN AT OR BELOW (altitude). CAUTION (wake turbulence or other reasons above). LAND AND CONTACT TOWER, or HOLD FOR (reason- takeoff clearance, release, landing/taxiing aircraft, etc.)

NOTE

Air‐taxi is the preferred method for helicopter movements on airports provided ground operations/conditions permit. Air‐taxi authorizes the pilot to proceed above the surface either via hover‐taxi or flight at speeds more than 20 knots. Unless otherwise requested or instructed, the pilot is expected to remain below 100 feet AGL. The pilot is solely responsible for selecting a safe airspeed for the altitude/operation being conducted.

REFERENCE

P/CG Term - Air Taxi. AIM, Para 4-3-17, VFR Helicopter Operations at Controlled Airports.

WAKE TURBULENCE APPLICATION
d.

Avoid clearances which require small aircraft or helicopters to taxi in close proximity to taxiing or hover‐taxi helicopters.

REFERENCE

AC 90-23, Aircraft Wake Turbulence, Para 10 and Para 11.

3-11-2 HELICOPTER/POWERED‐LIFT TAKEOFF CLEARANCE

a.

Issue helicopter or powered‐lift takeoff clearances from movement areas other than active runways or in diverse directions from active runways, with additional instructions as necessary. Whenever possible, issue takeoff clearance in lieu of extended hover‐taxi or air‐taxi operations.

PHRASEOLOGY

(Present position, taxiway, helipad, numbers) MAKE RIGHT/LEFT TURN FOR (direction, points of compass, heading, NAVAID radial) DEPARTURE/DEPARTURE ROUTE (number, name, or code), AVOID (aircraft/vehicles/personnel), or REMAIN (direction) OF (active runways, parking areas, passenger terminals, etc.). CAUTION (power lines, unlighted obstructions, trees, wake turbulence, etc.). CLEARED FOR TAKEOFF.

b.

If takeoff is requested from non‐movement areas, an area not authorized for helicopter or powered‐lift aircraft use, or an area off the airport, and, in your judgment, the operation appears to be reasonable, use the following phraseology instead of the takeoff clearance in subparagraph a.

PHRASEOLOGY

DEPARTURE FROM (requested location) WILL BE AT YOUR OWN RISK (additional instructions, as necessary). USE CAUTION (if applicable).

c.

Unless agreed to by the pilot, do not issue downwind takeoffs if the tailwind exceeds 5 knots.

NOTE

A pilot request to takeoff from a given point in a given direction constitutes agreement.

3-11-3 HELICOPTER/POWERED‐LIFT DEPARTURE SEPARATION

Separate a departing helicopter or powered‐lift aircraft from other helicopters or powered‐lift aircraft by ensuring that it does not takeoff until one of the following conditions exists:

NOTE

Helicopters or powered‐lift aircraft performing air‐taxiing operations within the boundary of the airport are considered to be taxiing aircraft.

a.

A preceding, departing helicopter or powered‐lift aircraft has left the takeoff area. (See FIG 3-11-1.)

FIG 3-11-1 Helicopter Departure Separation

b.

A preceding, arriving helicopter or powered‐lift aircraft has taxied off the landing area. (See FIG 3-11-2.)

FIG 3-11-2 Helicopter Departure Separation

3-11-4 HELICOPTER/POWERED‐LIFT ARRIVAL SEPARATION

Separate an arriving helicopter or powered‐lift aircraft from other helicopters or powered‐lift aircraft by ensuring that it does not land until one of the following conditions exists:

a.

A preceding, arriving helicopter or powered‐lift aircraft has come to a stop or taxied off the landing area. (See FIG 3-11-3 and FIG 3-11-4.)

FIG 3-11-3 Helicopter Arrival Separation

FIG 3-11-4 Helicopter Arrival Separation

b.

A preceding, departing helicopter or powered‐lift aircraft has left the landing area. (See FIG 3-11-5.)

FIG 3-11-5 Helicopter Arrival Separation

3-11-5 SIMULTANEOUS LANDINGS OR TAKEOFFS

Authorize helicopters or powered‐lift aircraft to conduct simultaneous landings or takeoffs if the distance between the landing or takeoff points is at least 200 feet and the courses to be flown do not conflict. Refer to surface markings to determine the 200 foot minimum or instruct a helicopter or powered‐lift aircraft to remain at least 200 feet from another helicopter or powered‐lift aircraft. (See FIG 3-11-6.)

FIG 3-11-6 Simultaneous Helicopter Landings or Takeoffs

3-11-6 HELICOPTER/POWERED‐LIFT LANDING CLEARANCE

a.

Issue landing clearances to helicopters or powered‐lift aircraft going to movement areas other than active runways or from diverse directions to points on active runways, with additional instructions as necessary. Whenever possible, issue a landing clearance in lieu of extended hover‐taxi or air‐taxi operations.

PHRASEOLOGY

MAKE APPROACH STRAIGHT‐IN/CIRCLING LEFT/RIGHT TURN TO (location, runway, taxiway, helipad, vertipad, Maltese cross) ARRIVAL/ARRIVAL ROUTE (number, name, or code). HOLD SHORT OF (active runway, extended runway centerline, other). REMAIN (direction/distance; e.g., 700 feet, 1 1/2 miles) OF/FROM (runway, runway centerline, other helicopter/aircraft). CAUTION (power lines, unlighted obstructions, wake turbulence, etc.). CLEARED TO LAND.

b.

If landing is requested to non‐movement areas, an area not authorized for helicopter or powered‐lift aircraft use, or an area off the airport, and, in your judgment, the operation appears to be reasonable, use the following phraseology instead of the landing clearance in subparagraph a.

PHRASEOLOGY

LANDING AT (requested location) WILL BE AT YOUR OWN RISK (additional instructions, as necessary). USE CAUTION (if applicable).

c.

Unless agreed to by the pilot, do not issue downwind landings if the tailwind exceeds 5 knots.

NOTE

A pilot request to land at a given point from a given direction constitutes agreement.

Referenced in This Section

AIM 4-3-17
Previous Section3-10 Arrival Procedures and SeparationNext Section 3-12 Sea Lane Operations

You Are Reading

3-11-1 TAXI AND GROUND MOVEMENT OPERATION

Read Citation (on FlightPush)