PHAK 1-4

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 11 Rock Springs 12 Salt Lake City 13 Elko 14 Reno 15 San Francisco 1 New York 2 Bellefonte 3 Cleveland 4 Bryan 5 Chicago 6 Iowa City 7 Omaha 8 North Platte 9 Cheyenne 10 Rawlins Figure 1-6. The transcontinental airmail route ran from New York to San Francisco. Figure 1-5. The de Haviland DH-4 on the New York to San Francisco inaugural route in 1921. mass produced to serve as fighters, bombers, trainers, as well as reconnaissance platforms. Aviation advocates continued to look for ways to use airplanes. Airmail service was a popular idea, but the war prevented the Postal Service from having access to airplanes. The War Department and Postal Service reached an agreement in 1918. The Army would use the mail service to train its pilots in flying cross-country. The first airmail flight was conducted on May 15, 1918, between New York and Washington, DC. The flight was not considered spectacular; the pilot became lost and landed at the wrong airfield. In August of 1918, the United States Postal Service took control of the airmail routes and brought the existing Army airmail pilots and their planes into the program as postal employees. Transcontinental Air Mail Route Airmail routes continued to expand until the Transcontinental Mail Route was inaugurated. [Figure 1-5] This route spanned from San Francisco to New York for a total distance of 2,612 miles with 13 intermediate stops along the way. [Figure 1-6] On May 20, 1926, Congress passed the Air Commerce Act, which served as the cornerstone for aviation within the United States. This legislation was supported by leaders in the aviation industry who felt that the airplane could not reach its full potential without assistance from the Federal Government in improving safety. The Air Commerce Act charged the Secretary of Commerce with fostering air commerce, issuing and enforcing air traffic rules, licensing pilots, certificating aircraft, establishing airways, and operating and maintaining aids to air navigation. The Department of Commerce created a new Aeronautics Branch whose primary mission was to provide oversight for the aviation industry. In addition, the Aeronautics Branch took over the construction and operation of the nation’s system of lighted airways. The Postal Service, as part of the Transcontinental Air Mail Route system, had initiated this system. The Department of Commerce made significant advances in aviation communications, including the introduction of radio beacons as an effective means of navigation. Built at intervals of approximately 10 miles apart, the standard beacon tower was 51 feet high, and was topped with a powerful rotating light. Below the rotating light, two course lights pointed forward and back along the airway. The course lights flashed a code to identify the beacon’s number. The tower usually stood in the center of a concrete arrow 70 feet long. A generator shed, where required, stood at the “feather” end of the arrow. [Figure 1-7] Federal Certification of Pilots and Mechanics The Aeronautics Branch of the Department of Commerce began pilot certification with the first license issued on April 6, 1927. The recipient was the Chief of the Aeronautics Branch, William P. MacCracken, Jr. [Figure 1-8] (Orville Wright, who was no longer an active flier, had declined the honor.) MacCracken’s license was the first issued to a pilot by a civilian agency of the Federal Government. Some 3 months later, the Aeronautics Branch issued the first Federal aircraft mechanic license. Equally important for safety was the establishment of a system of certification for aircraft. On March 29, 1927, the Aeronautics Branch issued the first airworthiness type certificate to the Buhl Airster CA-3, a three-place open biplane. In 1934, to recognize the tremendous strides made in aviation and to display the enhanced status within the department, the Aeronautics Branch was renamed the Bureau of Air Commerce. [Figure 1-9] Within this time frame, the Bureau of Air Commerce brought together a group of airlines